56-17 Mineral Nutrient Recovery in Co-Products of Pyrolysis for Varied Biomass Feedstocks.

See more from this Division: A10 Bioenergy and Agroindustrial Systems
See more from this Session: Bioenergy Production, Modeling, Sustainability, and Policy
Monday, November 1, 2010
Long Beach Convention Center, Exhibit Hall BC, Lower Level

Jatara Wise1, Tony Provin2, Derek Husmoen3, Ronnie Schnell4, Donald Vietor3, Sergio Capareda3 and Clyde Munster3, (1)Texas A&M University Dept. of Soil and Crop Sciences, Bryan, TX
(2)Texas Agrilife Extension Service, College Station, TX
(3)Texas A&M University, College Station, TX
(4)Texas A&M University, Giddings, TX
Plant biomass can be pyrolyzed under oxygen-free conditions and high temperature to produce fuel, bio-oil and synthesis gas, leaving behind a charcoal byproduct commonly termed “bio-char.” Sustainable bioenergy systems will require recycling of bio-char to replenish soil nutrients on original fields used to produce biomass for pyrolysis. However, little research is available illustrating the relationship between feedstock properties, bio-char yield, and conservation of plant nutrients under varying pyrolysis temperatures and inert gas flow-rates. Some research suggests limited recovery of key plant nutrients in bio-char indicates that these nutrients are present in the bio-oil or synthesis gas. This research studies the relationship between classic fiber analysis of forages and bio-char yield. In addition, mass balance of plant nutrients was quantified in the bio-char, bio-oil and synthesis gas derived from pyrolysis of three biomass feedstocks (high-energy sorghum, corn stover, and switchgrass) at controlled temperature and gas flow rate. Significant differences in bio-char yield were observed among inert-gas flow rates and feedstocks (p<0.05), but bio-char yields were not correlated with feedstock fiber or ash contents. Analysis of bio-char samples indicated poor mass-balance recovery of potassium, phosphorus and other nutrients in the bio-char. For sorghum, less than 60% of pre-pyrolysis biomass potassium and phosphorus was recovered in bio-char. Low recoveries in bio-char were due, in part, to potassium and phosphorus recovery in remaining co-products, including condensed tar and bio-oil and non-condensable synthesis gas. Bio-oil and tar fractions revealed recovery of nearly 15% of biomass potassium, but recovery of less than 1% of biomass phosphorus. The synthesis gas acid trap captured less than 4% of biomass phosphorus and slightly over 35% of the biomass potassium. Filter paper was used remove residue from the acid trap and contained nutrient levels similar to the bio-oil and tar fractions. Low nutrient recovery in recycled bio-char could limit nutrient return to production fields and sustainability of feedstock production.