376-7 Comparison of Transient State Models That Include Salinity and Matric Stress Effects On Plant Yield.

Poster Number 419

See more from this Division: S06 Soil & Water Management & Conservation
See more from this Session: General Soil & Water Management & Conservation
Wednesday, October 19, 2011
Henry Gonzalez Convention Center, Hall C
Share |

James D. Oster1, J. Letey2, Peter Vaughan3, Laosheng Wu2 and Manzoor Qadir4, (1)University of California-Riverside, Riverside, CA
(2)Environmental Science Department, Riverside, CA
(3)ICARDA - Intl Center for Agricultural Research in the Dry Areas, Redwood City, CA
(4)ICARDA - Intl Center for Agricultural Research in the Dry Areas, Aleppo, , SYRIAN ARAB REPUBLIC

Transient-state models that account for continually changing salinity and matric stress on crop yields have been developed by several research groups. The objective of this research was to compare the simulated yields of forage corn obtained from a common set of soil and water conditions for ENVIRO-GRO, HYDRUS, SALTMED, SWAP and UNSATCHEM. The physical and hydraulic properties of Panoche clay loam were used. The amounts of water applied weekly ranged from 0.9 to 1.3 times the potential crop transpiration rates (Kirr) based on the climatic conditions in the San Joaquin Valley of California. The salinity of the applied water (ECiw) ranged from 0.5 to 6 dS/m, which brackets the threshold soil-water salinity of forage corn which is 3.6 dS/m.  The model simulations were run for sufficient back-to-back crop seasons to establish transient matric and osmotic conditions within the rootzone that did not change from one crop season to the next, a dynamic steady-state condition. SALTMED simulated lower relative yields (RY) than the other models for all combinations of Kirr and ECiw. For the other models, RY values were similar (within about 0.07 or less) for ECiw ≤ 3 dS/m for all Kirr values. The plots of RY versus ECiw for HYDRUS, SWAP, and UNSATCHEM approximately paralleled each other except that UNSATCHEM produced higher values. ENVIRO-GRO produced the highest RY where Kirr ≥ 1.1 and ECiw ≤ 2.0 dS/m but decreased more rapidly with increased ECiw.  ENVIRO-GRO has  plant-based compensation which allows water uptake to meet potential transpiration demands as long as any portion of the root zone is not exposed to matric or osmotic stress that exceed threshold levels; a factor that produced higher RY at the lower ECiw values. The reason for the more rapid decrease in RY with increasing values of ECiw produced by ENVIRO-GRO is that it assumed that the osmotic and matric stresses were additive, whereas the others assumed that they were multiplicative. All the models except UNSATCHEM assume a constant relationship between EC and salt concentration in solution.  UNSATCHEM takes into account the effects of the ionic composition and ion concentration on osmotic potential, to which we attribute the higher RY values obtained with this model. Since the chemical composition of irrigation waters are all unique, this aspect of UNSATCHEM poses an important capability in the assessment of osmotic effects on crop yields. We conclude the models provide a valuable resource to assess the utility of moderately saline irrigation waters, for a broad range of transient conditions which include variable crops, precipitation, irrigation water management, and irrigation water salinity.

See more from this Division: S06 Soil & Water Management & Conservation
See more from this Session: General Soil & Water Management & Conservation